En/3.2/Uninterruptible power supply

From Zentyal Linux Small Business Server
Jump to: navigation, search

UPS Configuration with Zentyal

If you want to configure an UPS with Zentyal, you will have to connect it to your server. Install and enable the UPS Management module and go to Maintenance ‣ UPS

List of configured UPS

You have to fill the following parameters to configure a new UPS hardware.

Adding a new UPS

UPS labelLabel to name this UPS.

DescriptionDescription associated to this UPS.

DriverDriver that will manage the data read and write in your UPS, you have to enter the manufacturer in the left field and model in the next one. In the last field you can see the associated driver.

PortUPS using serial ports can not be auto detected, so you will need to specify the port. If you are using USB UPS Autodetect should be enough.

Serial numberIn case you have several UPS attached to your server's USB, you can stablish specific configuration differentiated by the serial number.

If you go to Configuration of your UPS, you can edit the configurations and browse the avaiable variables.

Depending on the model of your UPS, different configuration parameters will be published. However, they usually have a similar set of parameters and names.

Example of available configurations for your UPS:

Available configuration parameters

If you go to UPS settings you will see a list of modifiable parameters. Some of the most used will be ups.delay.shutdown (Time delay after sending the shutdown signal to the server when the UPS shuts down itself) or *battery.charge.low (battery threshold to send the shutdown signal to the server).

Example of variables available for the UPS

UPS Variables

The variables are read-only parameters for example battery.charge or battery.temperature

Personal tools


Zentyal Wiki

Zentyal Doc